Water marble nails are a nail art technique implicating dropping nail lacquers into crystal clear water and generating a pattern on the water surface, the pattern conceived is then deported to the nails. This marbling technique in nail art is done by adding nail polish into a bowl of water and slightly wriggling the colors around so that when you drench your fingers in it, you end up with a very classy-looking marble effect on your nails! It’s much easier than it sounds. Here we have amazing marble nail art designs and ideas. Check them out below.

1. Neon Marbled Nail Art

This neon marble art will make your nails look fresh, funky and fetish. Also, it is very easy to do with them too. In a bowl of water, start by adding few drops of the nail polish you wish to apply. Then keep reckoning the different variants of nail colors in a circular form side by side. After that’s done, use the toothpick to whirlpool around the colors. Wriggle them around till the time, the design makes you satisfied enough. Once done, you should dip your fingers into the color scheme made, one by one. Create the similar pattern in a similar way once again in the water, if it’s not enough for the nails. Use a cotton sponge drenched in nail polish remover to clear up the area around the nails. Finally, seal it with a top coat, and you’re done with those fashionable nails.

2. Groovy Marbled Nail Art

One thing common to all those marbled nail arts is to dip nails into the water. But, this groovy style of marbled nail art is marginally different. In such a type, art is first created and then dried and later cut into sizes to make them fit on one’s nails. One can reuse it too. Begin by adding the three nail polish colors into the bowl of water in a way that they form concentric circles. Use a toothpick after that to create lines in the similar pattern inside out. Leave it for some time allowing it to completely dry and place it on a paper towel after that. Now, you can cut them up into pieces so that they fit on your nail. You can storehouse them in a cool, dry place and use them whenever you need them again. To use them, you will have to give a white coat as a base, and apply a safeguarding layer around the nails in order to avoid any filth or mess, or to make it easier, you can just clean it up with nail polish remover later on. On wet polish applied, place your cut out designs on the nail. Do this for all the nails and clean up the sides that emerge. Finally, apply a layer of last coat, and you’re done with this groovy marbled art.